HAND HELD INSTUMENT FOR PORT MAPPING AND MEASURING VELOCITIES IN PORTS.
TUBES CONNECT YOUR AUXILLARY MANOMETER TO THE PITOT TUBE AND PRESSURE IS MEASURED
A pitot (pronounced /'pi?to?/) tube is a pressure measurement instrument used to measure fluid flow velocity. The pitot tube was invented by the French engineer Henri Pitot in the early 1700s[1] and was modified to its modern form in the mid 1800s by French scientist Henry Darcy[2]. It is widely used to determine the airspeed of an aircraft and to measure air and gas velocities in industrial applications.
Contents
1 Theory of Operation
2 Industry applications
3 See also
4 References
5 External links
Theory of Operation
The basic pitot tube consists of a tube pointing directly into the fluid flow. As this tube contains fluid, a pressure can be measured; the moving fluid is brought to rest (stagnates) as there is no outlet to allow flow to continue. This pressure is the stagnation pressure of the fluid, also known as the total pressure or (particularly in aviation) the pitot pressure.
The measured stagnation pressure cannot of itself be used to determine the fluid velocity (airspeed in aviation). However, Bernoulli's equation states:
Stagnation Pressure = Static Pressure + Dynamic Pressure
Which can also be written
Solving that for velocity we get:
Where V is fluid velocity
and pt is stagnation or total pressure
and ps is static pressure
and ? is fluid density
The dynamic pressure, then, is the difference between the stagnation pressure and the static pressure. The static pressure is generally measured using the static ports on the side of the fuselage. The dynamic pressure is then determined using a diaphragm inside an enclosed container. If the air on one side of the diaphragm is at the static pressure, and the other at the stagnation pressure, then the deflection of the diaphragm is proportional to the dynamic pressure, which can then be used to determine the indicated airspeed of the aircraft. The diaphragm arrangement is typically contained within the airspeed indicator, which converts the dynamic pressure to an airspeed reading by means of mechanical levers.
Instead of static ports, a pitot-static tube (also called a Prandtl tube) may be employed, which has a second tube coaxial with the pitot tube with holes on the sides, outside the direct airflow, to measure the static pressure.
Pitot tubes on aircraft commonly have heating elements called pitot heat to prevent the tube from becoming clogged with ice. The failure of these systems can have catastrophic consequences, as in the case of Austral Líneas Aéreas Flight 2553, Birgenair Flight 301 (investigators suspected that some kind of insect could have created a nest inside the pitot tube. The prime suspect is a species called the Black and yellow mud dauber wasp), Northwest Orient Airlines Flight 6231, AeroPeru Flight 603 (blocked static port), and of one X-31.[3]
Industry applications
Pitot tube from a F/A-18In industry, the velocities being measured are often those flowing in ducts and tubing where measurements by an anemometer would be difficult to obtain. In these kinds of measurements, the most practical instrument to use is the pitot tube. The pitot tube can be inserted through a small hole in the duct with the pitot connected to a U-tube water gauge or some other differential pressure gauge (alnor) for determining the velocity inside the ducted wind tunnel. One use of this technique is to determine the amount of cooling that is happening to a room.
The fluid flow rate in a duct can then be estimated from:
Volume Flow Rate (cubic feet per minute) = Duct Area (square feet) × Velocity (feet per minute)
Volume Flow Rate (cubic meters per second) = Duct Area (square meters) × Velocity (meters per second)
In aviation, air speed is typically measured in knots.
800-841-5405, 712-852-4627